paxpos.blogg.se

Support Worldwide Technical Support and Product Information ni.com National Instruments Corporate Headquarters 11500 North Mopac Expressway

To find the correct value of output voltage, we should use the correct component.Educators Manual TitleShort-Hidden (cross reference text) After battery disconnect we can see the circuit still shown the output voltage.įrom here we know that the capacitor 1 farad keep the charge. It also the component that use is not match from schematic. It is maybe that cause by battery that use in bread board less than that required. check the output voltage by using multimeter or voltmeter in Dc.įrom both value there have a different output value of voltage.In this multisim also used 9 volt battery.Construct the circuit following the schematic of solar power.Select all component that listed on schematic circuit.Open the software, and than create a new project.

Step 2 is to simulate the solar power by using Software Multisim 2001.Put the probe to the output of circuit, and reading from the multimeter record.The circuit run and to check the output voltage use the multimeter.After finish construct the circuit, double check the flow of circuit before running.Battery 9 volt used in that circuit to replace solar panel.Make sure the terminal and polarity of each component is correct to connect.Construct the circuit following the schematic that prepare.Prepare all the component that use in solar power regulator.Step one is to construct the circuit by using bread board.